Stilevs SB-168 SU, Instruction Manual

Page: 12 / 20

12
IV. USING THE APPLIANCE
• Tear off the hygienic sleeve on the bottle cap of pure water bottle, then
pu into the bottom of the water dispenser. Put the pumping pipe into
the bottle.
• Turn on the power switch (yellow switch), the water pump starts work
(yellow indicator light turns on, express status of water reflenishing),
after the water level of the machine reaches the specified position,
water pump stop working (yellow indicator light turns off).
• Press the water tap tol et off the air in the tank until water comes out.
Knock the tap for several times in order to prevent the water channel
from being clogged with air bubbles.
• When the water dispenser is used at the first time or after a long time
stopping, wash the tank inside for 2 times with püre water.
• It is only after finishing the above processes that you can connect the
power.
• Turn round the hot water switch (red) at the place of “on” and the red
light flashes. If you do not want to use hot water, turn the switch at
“off” and the water coming out is normally warm.
• Turn the cold water switch (blue) round at the place of “on” and the
green light flashes.
• When the red light turns off automatically, the hot water has got to
90-95 degrees to be fit for drinking. When the hot water temperature
is below 80 degrees, the red light flashes and the water is going to be
heated up automatically.
• When the green light turns off automatically, the cool water temperature
is below 10°C to be fit for drinking.
• Remove power plug or disconnect from the mains before performing
any maintenance the machine.
• Do not use steam or any steam cleaner and do not directly spray water
on the surface of the machine. Otherwise steam or water grains can
be contacted to electric current of the machine and can caused short
circuit or electric schock.
• Clean the surface of the machine with soft cloth or sponge which had
been soaked with sodium bicarbonated warm water. Use the cloth or
the sponge after wringing out well. Never use abrasive materials or
chemical cleaners (such as thinner, bleach, powder detergent)
V. CLEANING & MAINTENANCE
• Do not use noxious chemical materials during cleaning the water tanks.
• Once a year remove the dusts from the back of machine with brush or