Stihl SR 430, Manual

Page: 45 / 111

44 SR 430, SR 450
Installing
: Fit the rope rotor on the starter
post so that the inner spring
loop (arrow) engages the
recess (1).
– Fit the cover washer.
– Install the pawls and spring clip,
b 6.3
– Install the starter rope, b 6.5
– Tension the rewind spring, b 6.6
– Lubricate pegs on pawls with
grease, b 13
– Reassemble all other parts in the
reverse sequence.
6.5 Starter Rope / Grip
– Remove the starter cover, b 6.2
– Relieve tension of rewind spring,
b 6.4
The system will not be under
tension if the starter rope is broken.
– Remove remaining rope from the
rope rotor and starter grip.
Do not shorten the starter rope.
– Remove the rope rotor, b 6.4
0002RA114 TG
1
: Push the end of the starter
rope (1) out a little and undo the
knot.
– Pull the starter rope out of the
rotor.
: Use a suitable tool to pry the
cap (1) out of the starter grip.
0002RA115 TG
1
0002RA117 TG
1
: Pull the sleeve, washers, spring
and remaining rope (arrow) out of
the grip.
– Pull the remaining rope out of the
sleeve.
Do not shorten the starter rope.
– Thread the new starter rope
through the sleeve.
– Tie a simple overhand knot in the
end of the new rope.
– Fit the washers and spring.
: Thread the starter rope with
sleeve, spring and washers
through the starter grip (1).
Make sure the washers and spring
remain on the sleeve while the rope
its being pulled into the grip.
0002RA118 TG
0002RA119 TG
1