SP 451, SP 481
English
7
Working Position
N
With the harvester suspended from
the harness (3), hold the control
handle with your right hand and hold
and control the unit with your left
hand on the front handle (4).
N
Open the throttle and begin work
Mounting the Shaft
N
Place the powerhead on a clean
and flat surface so that it is resting
on the guard plate and the machine
support (under the front handle).
N
Place the shaft (1) in front of the
powerhead and check that both
parts form a straight line.
N
Push back the hand guard (2) to
expose the thread (3) on the
pushrod.
N
Hold the hand guard in this position
and screw the shaft (1) onto the
pushrod's thread by hand – as far as
stop.
N
Position the 27mm open-end
wrench on the pushrod's hexagon.
N
Position the 34mm open-end
wrench on the shaft's hexagon.
Do not grip the shaft during
operation because its movements
will otherwise be transmitted
directly to your body – the
anitivibration system will be
bypassed – see also section on
"Vibrations" in "Safety Precautions
and Working Techniques".
3
4902BA004 KN
4
Assembling the Unit
Make sure the ends of the shaft
and pushrod are clean.
4902BA005 KN
1
1
3
2
4902BA006 KN
4902BA007 KN
SW 27
SW 34