Stihl RE 150 PLUS, Instruction Manual, Page: 14 / 28

NOTICE
■ If the pressure washer does not suck in water,
the pump may run dry and the pressure
washer may be damaged.
► If no water escapes from the high-pressure
hose after two minutes: Switch off pressure
washer and check water supply.
► Switch off pressure washer.
► Connect the spray gun to the high-pressure
hose.
► Press and hold down spray gun trigger.
► Switch on pressure washer.
8 Connecting the pressure
washer to the power supply
8.1 Connecting the pressure
washer to the power supply
1
3
4
2
0000-GXX-9169-A0
► Turn the rotary switch (1) to the 0 position.
► Swivel lower holder (2) downwards.
► Remove connecting cord (3).
► Plug the plug (4) of the connecting cord into a
correctly installed socket.
9 Switching the pressure
washer on and off
9.1 Switch on high-pressure
washer
When the pressure washer is switched on, volt‐
age fluctuations may occur under unfavorable
mains conditions. The voltage fluctuations may
negatively affect other connected electrical appli‐
ances.
0000-GXX-4357-A0
► Turn the rotary switch to the I position.
9.2 Switching off the pressure
washer
0000-GXX-4358-A0
► Turn the rotary switch to the 0 position.
10 Operating the pressure
washer
10.1 Holding and controlling the
spray gun
0000-GXX-4359-A0
► Hold the spray gun by the handle with one
hand, wrapping your thumb around the han‐
dle.
► Hold the spray lance firmly with your other
hand, wrapping your thumb around the spray
lance.
English 8 Connecting the pressure washer to the power supply
14 0458-663-0121-C