Stihl RE 130 PLUS, Instruction Manual

Page: 22 / 84

0458-624-8221-A
20
English 9 Connecting the Water Supply
► Pull on the high-pressure nozzle and confirm that it is
seated securely.
► If the nozzle is difficult to insert, apply a food-safe fitting
grease to the sealing surface on the spray lance.
8.4.2 Removing the Spray Nozzle
WARNING
To reduce the risk of severe injury from unintended
spraying, switch off the pressure washer, relieve system
pressure and lock the spray gun trigger before attempting to
adjust or change a spray nozzle or other accessory.
To remove the spray nozzle:
► Switch off the pressure washer,
@
10.2.
► Pull the spray gun trigger to relieve pressure.
► Lock the spray gun trigger.
► Press down and hold the locking lever (1).
► Pull out the nozzle (2).
9.1 Connecting the Pressure Washer to the Mains
Water Supply
WARNING
Make sure the pressure washer is switched off and
disconnected from the power supply before connecting to or
disconnecting from the mains water supply.
Connecting the water filter
If the pressure washer is to be operated with sandy water or
with water from cisterns, a water filter must be connected in-
line between the water hose and the pressure washer. The
water filter filters sand and dirt out of the water and thus
protects the components of the pressure washer from
damage.
To connect the water filter:
► Unscrew the coupling (1).
► Screw the water filter (2) onto the connector (3) and
tighten by hand.
► Screw the coupling (1) onto the water filter (2) and tighten
by hand.
2
1
0000-GXX-4353-A0
9 Connecting the Water Supply
3
0000-GXX-7824-A0
1
2