8
0457 363 0128 A L18
Only for use with STIHL trimmers. Check
trimmer manual for compatibility.
STIHL recommends the use of original STIHL
replacement parts and accessories.
WARNING
■ To reduce the risk of hearing damage, wear
sound barriers (ear plugs or ear muffs).
■ A cracked, damaged or worn out mowing
head may shatter at high speeds and cause
serious or fatal injury. To reduce risk of injury
from broken parts, check condition of
trimmer, mowing head and tighten screws
before starting work and at regular short
intervals thereafter.
■ Wear plate: Replace the wear plate
immediately if its wear marks (1) become
visible,
A. Do not use.
■ Replace the polymer blades if any one
becomes reduced in length to less than
83 mm (3.2 in.). To ensure proper balance,
all polymer blades must be replaced at the
same time.
■ Do not use the mowing head if the polymer
blades are worn,
B. Replace the polymer
blades immediately.
■ Check freedom of movement of the bearing
bushings before replacing the polymer blades
or the wear plate
C. Wash the bearing
bushings (2) and collar screws (1) in a non-
flammable liquid before replacing the polymer
blades or the wear plate, then dry and
lubricate with STIHL Multispray (3) sold
separately. Run for a brief period (about 5
minutes) and then retighten the collar screws.
Keep polymer blades and mowing lines in a
water bath between 12 hours and 24 hours
before use to increase their useful life.
SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY
INSTRUCTIONS
Read and follow all safety
precautions in manual for
your trimmer. Improper
use can cause serious or
fatal injury!
Objects may be thrown or
ricochet in all directions.
To reduce risk of injury to
operator, never operate a
trimmer without a
properly configured and
mounted deflector. Keep
bystanders at least 15 m
(50 ft.) away.
To reduce risk of eye injury, always
wear goggles or close-fitting
protective glasses with adequate
side protection that are impact-
rated and marked as complying
with and ANSI Z87 "+" (US), EN
166 (Europe) or your national
standard.
Summary of Contents for PolyCut 47-3
