MS 193 C
English
28
Choke shutter open (
j
)
–
if the engine is warm, i.e. if it has
been running for about one minute.
N
Hold and start your saw as
described.
When engine begins to fire
N
Move the choke lever (4) to the
open position (
j
).
N
Hold and start your saw as
described.
As soon as the engine runs
N
Press down trigger lockout and the
blip the throttle trigger (2) – the
Master Control lever (3) moves to
the run position (
F
) and the engine
settles down to idling speed.
N
Pull the hand guard toward the
handlebar to disengage the chain
brake.
NOTICE
Always disengage chain brake before
accelerating the engine. High revs with
the chain brake engaged (chain locked)
will quickly damage the clutch and chain
brake.
N
After a cold start, warm up the
engine at varying speeds – your saw
is ready for operation.
At very low outside temperatures
If idling behavior is erratic or
acceleration is poor:
N
Readjust carburetor if necessary,
see "Adjusting the Carburetor".
N
If your saw is very cold (frost or ice
on machine), start the engine and
keep it at a high idle speed (with
chain brake disengaged) until it
reaches normal operating
temperature.
Stopping the engine
N
Move Master Control lever to
Stop 0.
If the engine does not start
If you did not move the Master Control
lever from the choke closed
position (
l
) to the choke open
position (
j
) quickly enough after the
engine began to fire, the engine is
probably flooded.
N
Move Master Control lever to
Stop 0.
N
Remove the spark plug – see
"Spark Plug".
4
418BA004 KN
4
418BA004 KN
418BA007 KN
3
2
151BA005 KN
418BA008 KN