![background image](http://html1.mh-extra.com/html/stihl/ms-151-c/ms-151-c_instruction-manual_1378856010.webp)
–
never allow another person to hold the log or
help in any other way.
Limbing
–
use a low kickback chain.
–
Work with the saw supported wherever possi‐
ble.
–
do not stand on the log while limbing it.
–
do not cut with the bar nose.
–
watch for limbs which are under tension.
–
never cut several limbs at once.
Lying or standing logs under tension:
Always make the cuts in the correct order (first
compression side (1), then tension side (2)), oth‐
erwise the cutting attachment may stick in the cut
or kick back – risk of injury!
1
001BA151 KN
2
1
001BA152 KN
2
► Make relieving cut at the compression side (1)
► Make bucking cut at the tension side (2)
Be wary of pushback when making bucking cut
from the bottom upwards (underbuck).
NOTICE
Do not cut a lying log at a point where it is touch‐
ing the ground because the saw chain will other‐
wise be damaged.
Ripping:
001BA189 KN
Sawing technique without use of the spiked
bumper – risk of pull-in – position the guide bar at
as shallow an angle as possible – be especially
careful – increased risk of kickback!
4.2
Preparing for felling
Check that there are no other persons in the fell‐
ing area – other than helpers.
Make sure no-one is endangered by the falling
tree – the noise of your engine may drown any
warning calls.
001BA088 LÄ
2
/
1 2
1
1
/
1 2
Maintain a distance of at least 2 1/2 tree lengths
from the next felling site.
Determining direction of fall and escape path
Select gap in stand into which you want the tree
to fall.
Pay special attention to the following points:
–
The natural inclination of the tree
–
Unusually heavy limb structure, asymmetrical
growth, damage to tree
–
The wind direction and speed – do not fell in
high winds
–
Direction of slope
–
Neighboring trees
–
Snow load
–
Take the general condition of the tree into
account – be especially careful with trunk
damage or deadwood (brittle, rotten or dead
wood)
English
4 Working Techniques
10
0458-506-0121-C