5
MF-MM
English
Before Starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the instruction
manuals:
To reduce risk of injury from MultiTool
rotating in the wrong direction, check
that position of gearbox is correct and
adjust if necessary.
See chapter on "Mounting the
MultiTool".
Correct Position of Gearbox:
(when using dethatcher)
The axle (
1
) must be below the drive
shaft (
2
) so that the MultiTool rotates in
the direction of the arrow (
3
).
Position the gearbox for metal
attachments (top illustration) so that the
axle is below the drive shaft.
See also notes on "Before Starting" in
the MultiEngine instruction manual.
–
Attachments must be correctly and
securely mounted and in good
condition (clean, move freely, not
warped).
–
Mount both deflector extensions
and the mud flap.
–
Never attempt to modify the controls
or safety devices.
–
Keep the handles dry and clean for
safe control.
–
Set the handlebar to the normal
operating position and tighten down
firmly with the rotary knob. See
chapter on "Adjusting the
Handlebar" in the MultiEngine
instruction manual.
Always check your power tool for proper
condition and operation before starting.
Inspect the deflector, deflector
extensions and mud flap for damage or
wear.
Replace any damaged parts. Do not
operate the machine with a damaged
deflector. Replace damaged
attachments (e.g. tines) immediately.
2
469BA043 KN
1
3
