HT 75
English
9
The shaft should always be held at an
angle of 60° or less.
The least tiring working position is a tool
angle of 60°.
Any lesser angle may be used to suit the
situation.
Cross-cut
To avoid pinching the bar in the cut,
position the cutting attachment with the
hook against the branch and then
perform the cross-cut from the top
downwards.
Relieving cut
To avoid tearing the bark on thick
branches, always start by performing a
N
relieving cut (1) on the underside of
the branch. To do this, position the
cutting attachment and guide it
down to the bar nose in an arc.
N
Perform the cross-cut (2) – position
the bar with the hook against the
branch and then perform the cross-
cut
Flush-cutting thick branches
If branch diameter is more than 10 cm,
first
N
perform an undercut (3) and then
cross-cut at a distance of about 20
cm (A) from the final cut. Then carry
out the flush-cut (4), starting with a
relieving cut and finishing with a
cross-cut
390BA018 KN
0000003462_002
2
1
0000003451_002
3
4
A
390BA024 KN
