![background image](http://html.mh-extra.com/html/stihl/hla-66/hla-66_instruction-manual_1379716018.webp)
0458-185-8621-A
16
English
6 IMPORTANT SAFETY INSTRUCTIONS
■ To reduce the risk of severe personal injuries from
unintentional starting:
– Never touch the cutting blades with your hand or any
other part of your body when the battery is inserted,
even when the cutting blades are not moving.
■ The cutting blades continue to move for a short period
after the trigger switch is fully released.
– Wait for the cutting blades to stop before walking
with the hedge trimmer or putting it down.
■ In the event of an emergency:
– Switch off the motor immediately and remove the
battery.
■ Contacting foreign objects while cutting could damage the
cutting blades and may cause them to crack, chip, break
or jam. To reduce the risk of severe personal injury or
death from loss of control, and to reduce the risk of
damage to the hedge trimmer:
– Inspect the material to be cut and the surrounding
area for stones, fence wire, metal or other foreign
objects before starting work. Do not use the hedge
trimmer in areas where the cutting blades could
contact such objects.
– Take particular care when cutting next to, against or
near wire fences. Do not touch the wire with the
cutting blades.
– When working close to the ground, make sure that
no sand, grit or stones get between the cutting
blades.
– Do not cut any areas of the hedge, bush, shrub or
other vegetation that you cannot see.
■ The power tool has a large range. To reduce the risk of
personal or even fatal injury to bystanders from falling
objects or inadvertent contact with the moving cutting
blades of your power tool:
– Do not allow other persons in the general work area.
– If cutting the top of a taller hedge, check the other
side of the hedge frequently for bystanders, animals
and obstructions.
■ Check the cutting blades at regular short intervals during
operation, or immediately if there is a change in cutting
behavior:
– Switch off the hedge trimmer and remove the
battery.
– Check the condition, tightness and sharpness of the
cutting blades.
– Inspect the hedge trimmer for loose parts (nuts,
screws, etc.) and for cracked, bent, warped or
damaged cutting blades. Replace damaged cutting
blades before using the hedge trimmer.
– Always keep the cutting blades sharp.
■ To reduce blade friction and the buildup of dirt, which can
interfere with the proper functioning of the hedge trimmer:
– STIHL recommends that you spray the cutting
blades with a resin solvent, such as STIHL Resin
Remover and Lubricant, before starting work.
DANGER
■ Electricity can jump from one point to another by means of
arcing. Higher voltage increases the distance electricity
can arc. Electricity can also move through branches,
especially if they are wet. To reduce the risk of
electrocution:
– If the cutting blades become jammed by
branches or other obstructions, switch
off the hedge trimmer immediately and
remove the battery before attempting to
free the blades.
– Always keep bystanders at least
17 ft. (5 m) away when the
power tool is in use.