Stihl HLA 135, Instruction Manual, Page: 11 / 28

6.2 Displaying the charge level
0000079877_002
20-40%
40-60%
60-80%
80-100%
0-20%
1
► Press the button (1).
The LEDs light up green for about 5 seconds
and indicate the state of charge.
► If the LED on the right flashes green: Charge
the battery.
6.3 LEDs on Battery
The LEDs can show the state of charge or mal‐
functions. The LEDs can glow or flash green or
red.
The state of charge is indicated when the LEDs
glow or flash green.
► If the LEDs glow or flash red: Troubleshooting,
19.
There is a malfunction in hedge trimmer or
battery.
7 Activating and Deactivating
Bluetooth® Radio Interface
7.1 Activating the Bluetooth
®
Radio
Interface
► If the battery has a Bluetooth ®
radio interface:
Press and hold the pushbutton until the
"BLUETOOTH
®
" LED next to the symbol
lights up blue for approximately 3 seconds.
The Bluetooth
®
radio interface on the battery
is activated.
7.2 Deactivating the Bluetooth
®
Radio Interface
► If the battery has a Bluetooth
®
radio interface:
Press and hold the pushbutton until the
"BLUETOOTH
®
" LED next to the symbol
lights up blue six times.
The Bluetooth
®
radio interface on the battery
is deactivated.
8 Assembling the Hedge
Trimmer
8.1 Assembling the Long-Reach
Hedge Trimmer
► Switch off the long-reach hedge trimmer and
remove the battery.
1 4
3
2
3
5
a
90°
90°
0000098180_001
► Remove the protective cap (1).
► Undo the screws (2).
► Push the transmission (3) onto the shaft (4) in
such a way that the following conditions are
met:
–
In case of assembly of an HLA 135:
a = approx. 53 cm
–
In case of assembly of an HLA 135 K:
a = approx. 38 cm
► Align the housing (5) and transmission (3) as
shown.
► Tighten down the screws (2) firmly.
The long-reach hedge trimmer does not need to
be dismantled again.
8.2 Mounting the Loop Handle
(HLA 135)
► Switch off the long-reach hedge trimmer and
remove the battery.
7
4
6
5
1
1
2
2
3
7
a
0000097311_001
► Fit the clamp (4) in the loop handle (3).
► Place the loop handle (3) with clamp (4) on the
shaft (5).
► Fit the washers (2) on the screws (1).
► Press the clamp (6) against the shaft (5).
► Insert the screws (1) through holes in the loop
handle (3) and clamps (4 and 6).
► Slide the loop handle (3) until the distance (a)
is 20 cm.
7 Activating and Deactivating Bluetooth® Radio Interface English
0458-683-0121-B 11