![background image](http://html1.mh-extra.com/html/stihl/fs-87/fs-87_instruction-manual_1379682017.webp)
FS 87, FS 87 R
English
15
Securing the loop handle
N
Secure the loop handle (4) about
20cm/8in (A) forward of the control
handle (9).
N
Line up the loop handle.
N
Tighten down the screws firmly –
lock the nuts if necessary.
The sleeve (10) (not fitted on all models)
must be between the loop handle and
the control handle.
Some machine versions are equipped
with a throttle cable adjuster on the
control handle.
A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
Adjust the throttle cable only after the
unit is fully assembled – the control
handle must be in the normal operating
position.
N
Use a suitable tool to push the slide
to the end of the slot (see
illustration).
N
Press down the throttle trigger
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
The carrying ring comes standard with
the machine or is available as a special
accessory.
For position of carrying ring see "Main
Parts".
N
Place the clamp (1) against the
drive tube with the tapped hole on
the left (viewed from engine).
N
Squeeze the two ends of the clamp
together and hold in that position.
N
Insert the M6x14 screw (2).
N
Line up the carrying ring.
N
Tighten down the screw firmly.
10
9
4
002BA147 KN
A
Adjusting the Throttle Cable
002BA163 KN
STOP
249BA017 KN
1
2
Fitting the Carrying Ring
002BA142 KN
1
2
1
Summary of Contents for FS 87
