Stihl FS 56, Instruction Manual

Page: 7 / 44

FS 56, FS 56 R, FS 56 C, FS 56 RC
English
5
–
Safety devices (e. g., deflector for
cutting attachments, rider plate) for
damage and/or wear. Always
replace damaged parts. Do not use
the machine with a damaged
deflector or worn rider plate (if the
writing and arrows are no longer
discernible)
–
Never attempt to modify the controls
or safety devices.
–
Keep the handles dry and clean –
free from oil and dirt – this is
important for safe control of the
machine
–
Adjust the harness and handle(s) to
suit your height and reach Note the
information in the chapters "Fitting
the Harness" and "Balancing the
Machine".
To reduce the risk of personal injury, do
not operate your power tool if it is
damaged or not properly assembled!
To prepare for emergencies when using
a harness: Practice setting down the
machine quickly. To avoid damage, do
not throw the machine to the ground
when practicing.
Starting the engine
Start the engine at least 3 meters from
the fueling spot, outdoors only.
Place the unit on firm ground in an open
area. Make sure you have good balance
and secure footing. Hold the unit
securely. The cutting attachment must
be clear of the ground and all other
obstructions because it may begin to run
when the engine starts.
This is a one-person machine – ensure
that there is no-one within 15 meters of
the machine, not even when starting the
power tool! Risk of injury due to ejected
objects!
Check engine idling: The cutting
attachment must remain at a standstill
when the engine idles – throttle trigger
released.
Keep easily combustible materials
(e. g., wood chips, bark, dry grass, fuel)
away from hot exhaust gases and hot
muffler surfaces – risk of fire!
Holding and guiding the machine
Always hold the unit firmly with both
hands on the handles.
Make sure you always have a firm and
secure footing.
For versions with bike handle
Right hand on control handle, left hand
on grip on handlebar.
For versions with loop handle
Left hand on loop handle, right hand on
control handle, even if you are left-
handed.
While working
Make sure you always have a firm and
secure footing.
In the event of impending danger or in
an emergency, shut off the engine
immediately – move the stop switch /
slide control in the direction of 0.
Avoid contact with the
cutting attachment – risk
of injury!
Do not drop-start the
power tool – start the
engine as described in
the User Manual. The
cutting attachment runs
on for a short while after
releasing the throttle trig
-
ger – coasting effect!
002BA257 KN
002BA080 KN