Stihl FS 56, Instruction Manual

Page: 6 / 44

FS 56, FS 56 R, FS 56 C, FS 56 RC
English
4
Transporting the machine
Always stop the engine.
Carry the machine hanging on the
harness or by the shaft in such a way
that it is balanced.
To reduce the risk of cut injuries, fit
transport guard on the cutting
attachment, even when carrying the tool
for short distances – see also "Mounting
the Transport Guard".
By vehicle: When transporting in a
vehicle, properly secure your machine to
prevent turnover, damage and fuel
spillage.
Refueling
Always shut off the engine before
refueling.
Do not fuel a hot engine – fuel may spill
and cause a fire.
Open the fuel cap carefully to allow any
pressure build-up in the tank to release
slowly and avoid fuel spillage.
Only refuel the machine in a well
ventilated place. If fuel has been spilled,
immediately clean the machine – do not
allow your clothes to be splashed with
fuel. If that happens, change your
clothes at once.
This helps reduce the risk of engine
vibrations causing an incorrectly
tightened fuel cap to loosen or come off
and spill fuel.
Check for leaks. Do not start the engine
if there is a fuel leak – serious or fatal
burns could result!
Before starting
Check that your power tool is properly
assembled and in good condition – refer
to appropriate chapters in the User
Manual.
–
Check the fuel system for leaks,
especially the visible parts, e. g.,
fuel cap, hose connections, manual
fuel pump (only in machines with a
manual fuel pump). In case of
leakage and damage, do not start
the engine – risk of fire! Have the
machine serviced by a dealer
before using it
–
Use only an approved combination
of cutting attachment, deflector,
handle and harness. All parts must
be assembled properly and
securely
–
The stop switch / slide control must
be easy to actuate
–
Check the choke lever, throttle
trigger and throttle trigger lockout
for smooth action – throttle trigger
must return automatically to idle
position. The choke lever must
spring back from the
g
and
<
positions to the run position
F
when
the throttle trigger lockout and
throttle trigger are squeezed
–
Check that the spark plug boot is
secure – a loose boot may cause
sparking that could ignite
combustible fumes and cause a fire!
–
Cutting attachment or
interchangeable attachment:
correctly fitted, secure and in
perfect condition
Avoid touching hot parts
of the machine and gear
-
box – risk of burns!
002BA601 KN
002BA272 KN
Gasoline is highly flam
-
mable – keep away from
fire or flame – do not spill
any fuel – no smoking.
After refueling, close the
fuel cap as tightly as
possible.