The bike handle can be left on the shaft.
6.2
Removing the Deflector and
the Limit Stop
6.2.1
Installing the Deflector and the Limit
Stop
► Shut off the engine.
1
2
0000097394_001
► Position the guard (1) on the gear housing.
► Insert the screws (2) and tighten them to a tor‐
que of 10 Nm.
6.2.2
Removing the Deflector and Limit Stop
► Shut off the engine.
► Take out screws.
► Remove deflector.
6.3
Mounting and Removing the
Mowing Head
6.3.1
Mounting the Mowing Head
► Shut off the engine.
1
1
2
3
4
4
0000097396_001
► Place the thrust plate (2) on the shaft (3) so
that its smaller diameter faces up.
► Fit the mowing head (1) on the shaft (3) and
turn it counterclockwise by hand.
► Insert the stop pin (4) in the bore up to the limit
stop and hold it depressed.
► Turn the mowing head (1) counterclockwise
until the stop pin (4) engages in position.
The shaft (3) is now blocked.
► Tighten down the mowing head (1) firmly by
hand.
► Remove the stop pin (4).
6.3.2
Removing the Mowing Head
► Shut off the engine.
► Insert the stop pin in the bore as far as stop
and hold it depressed.
► Rotate the mowing head until the stop pin
engages in position.
The shaft is now blocked.
► Unscrew the mowing head clockwise.
► Remove the thrust plate.
► Remove stop pin.
6.4
Removing and Installing Metal
Cutting Attachment
6.4.1
Mounting grass cutting blade, brush
knife or circular saw blade
► Shut off the engine.
7
5
4
3
2
1
6
0000097397_001
► Place the thrust plate (5) on the shaft (6) so
that its smaller diameter faces up.
► Place the metal cutting attachment (4) on the
thrust plate (5). If you are fitting a circular saw
blade or a grass cutting blade with more than
4 cutting edges: Its cutting edges must face in
the same direction as the arrow on the deflec‐
tor.
► Place the thrust washer (3) on the metal cut‐
ting attachment (4) so that its raised side faces
up.
► Place the rider plate (2) on the thrust washer
(3) so that its closed side faces up.
► Insert the stop pin (7) in the bore up to the limit
stop and hold it depressed.
► Rotate the metal cutting attachment (4) coun‐
terclockwise until the stop pin (7) engages in
position.
The shaft (6) is now blocked.
► Fit the nut (1) counterclockwise and tighten it
down firmly.
► Remove the stop pin (7).
English
6 Assembling the Trimmer
12
0458-844-0101-A
