FS 410 C K
English
28
Installing the Rope Rotor
N
Coat starter post uniformly with
STIHL gear lubricant – see "Special
Accessories".
N
Slip the rotor over the starter post –
turn it back and forth to engage the
anchor loop of the rewind spring.
N
Slip the carrier with pawls and
washer over the starter post – turn it
back and forth to engage the anchor
loop of the rewind spring in the
carrier.
N
Fit the E-clip (7) in the groove in the
starter post.
N
Push the spring clip (3) into position
– it must point counterclockwise as
shown and engage the pegs on the
pawls (2).
Tensioning the Rewind Spring
N
Pull the starter rope out of the
housing as far as stop and make a
loop.
N
Fit the tensioning wrench on the
carrier.
N
Use the tensioning wrench to rotate
the rotor six full turns
counterclockwise – the rope winds
itself around the tensioning wrench
in this process.
N
Hold the tensioning wrench steady
and unwind the rope.
N
Pull out and straighten the twisted
rope at the starter grip.
N
Hold the rope steady with the starter
grip.
N
Release the tensioning wrench and
rope slowly so that it winds onto the
rotor.
N
Remove the tensioning wrench.
The starter grip must locate firmly in the
guide bushing. If the grip droops to one
side: Add one more turn on the rope
rotor to increase spring tension.
When the starter rope is fully extended it
must still be possible to rotate the rotor
another full turn. If this is not the case,
the spring is overtensioned and could
break.
N
Take one turn of the rope off the
rotor.
9926BA035 KN
7
3
9926BA045 KN
2
2
9926BA046 KN
9926BA047 KN
9926BA048 KN
9926BA049 KN