•
Remove screw from hose clamp
for harness.
•
Pull the hose clamp apart and
take it off the drive tube.
Reassemble in the reverse
sequence.
- Degrease the clamp mounting
area.
•
Push the drive tube home so that
the holes line up.
- Tighten down fixing screw to
2.5 Nm and clamp screw to
5.5 Nm.
- Remove deflector or stop, if fitted.
•
Release clamp screws.
- Pull gearhead off the drive tube.
- For further disassembly and
assembly procedures see
"Standard Repairs and Trouble-
shooting" handbook.
- Degrease clamp mounting area.
- Slide the gearhead onto the dri-
ve tube - turn the output shaft
back and forth at the same time
so that the square end of the dri-
ve shaft engages the square sok-
ket in the drive pinion.
- Push the gearhead as far as
stop and line it up.
- Tighten down clamp screws
to 8.5 Nm.
- Refit the deflector or stop.
- Take rubber element (AV
system) out of clutch housing
-
•
Use pliers (1) 0816 610 1495 to
remove retaining ring from the
clutch drum stub.
•
Use drift (1) 1114 893 4700 to
press clutch drum out of ball bea-
ring.
FS 25-4, 65-4
41