![background image](http://html1.mh-extra.com/html/stihl/fc-75/fc-75_user-manual_1378585031.webp)
Throttle cable with one short-
circuit wire
•
Remove screw.
- Pull off handle.
•
Remove screws with screw-dri-
ver (1) 5910 890 2301.
- Separate the two halves of the
handle.
•
Slightly pull up interlock lever (1)
and turn it aside until torsion
spring (2) is relaxed.
•
Draw interlock lever off its pivot
pin.
•
Unhook torsion spring.
•
Pull throttle trigger (1) with tor-
sion spring (2) and fitted throttle
cable (3) off its pivot pin.
•
Unhook throttle cable from
throttle trigger.
The parts are assembled in rever-
se order.
•
After hooking in the throttle
cable, slip torsion spring over pi-
vot pin and slide the long leg of
the spring into the slot.
•
The interlock lever must lie
behind the throttle trigger.
- Screw both halves of the handle
together with a torque of 2.5 Nm.
Throttle trigger / interlock lever
31