![background image](http://html1.mh-extra.com/html/stihl/fc-75/fc-75_user-manual_1378585018.webp)
•
Slide cylinder over piston; the
clamping strap slips downward
and the piston rings slip into the
cylinder.
- Remove clamping strap and
assembly block.
- Line up cylinder and cylinder
gasket.
•
Tighten cylinder base screws to
a torque of 9.5 Nm with socket
(1) 0812 542 2104.
for further assembly steps.
- Remove piston,
Note: Coking residues must not
be allowed to enter the crankcase
when fitting the piston rings and/or
cleaning the grooves.
- Remove piston rings from piston.
•
Scrape the grooves clean with a
piece of old piston ring.
•
Fit the new piston rings in the
grooves so that the radii face
upwards.
- Install piston,
- Remove cylinder,
•
Unscrew starter carrier from
crankshaft stub.
•
Unscrew clutch from crankshaft
stub.
•
Pull flywheel off crankshaft stub,
392RA037 VA
145RA098
VA
392RA036 VA
366RA065
VA
145RA099
VA
366RA078 VA
392RA035
1
VA
18