Stihl BGA 60, Instruction Manual

Page: 33 / 92

Fault LEDs on the
battery
Cause Remedy
The blower or the bat‐
tery is damp.
► Allow blower or battery to dry, 18.6.
The blower swit‐
ches off while in
operation.
3 LEDs light up
red.
The blower is too
warm.
► Remove the battery.
► Allow the blower to cool down.
There is an electrical
fault.
► Remove battery and reinsert it.
► Switch on blower.
The blower ope‐
rating time is too
short.
The battery is not fully
charged.
► Fully charge the battery.
The battery service
life has been excee‐
ded.
► Replace battery.
Charging does
not start when
the battery is
inserted into the
charger.
1 LED emits
red light.
The battery is too
warm or too cold.
► Leave battery inserted in charger.
Charging starts automatically as soon as
the permitted temperature range is rea‐
ched.
17.2 Troubleshooting the Charger
Fault LED on Char‐
ger
Cause Remedy
Battery not being
charged.
The LED fla‐
shes red.
No electrical contact
between charger and
battery.
► Remove the battery.
► Clean contacts on charger.
► Insert battery.
There is a malfunction
in the charger.
► Do not use the charger and contact your
STIHL dealer for assistance.
18 Specifications
18.1 STIHL BGA 60 Blower
–
Approved battery: STIHL AK
–
Blowing force: 15 N
–
Maximum air velocity: 69 m/s
–
Average air velocity: 58 m/s
–
Air throughput rate: 780 m³/h
–
Weight without battery: 2.3 kg
Consult www.stihl.com/battery-life for the respec‐
tive running time.
18.2 STIHL AK Battery
–
Battery technology: lithium-ion
–
Voltage: 36 V
–
Capacity in Ah: see rating label
–
Energy content in Wh: see rating label
–
Weight in kg: See rating label
18.3 STIHL AL 101 Charger
–
Rated voltage: See rating plate
–
Frequency: see rating plate
–
Rated power: see rating plate
–
Charging current: See rating plate
For charging times, see www.stihl.com/charging-
times.
18.4 Extension Cords
If an extension cord is used, the cross sectional
area of its conductors must meet the following
minimum requirements – depending on the line
voltage and length of the extension cord:
If rated voltage on the rating label is 220V to
240V:
–
Cord length up to 20 m: AWG 15 / 1.5 mm²
–
Cord length 20 m up to 50 m: AWG 13 /
2.5 mm²
If rated voltage on the rating label is 100V to
127V:
–
Cord length up to 10 m: AWG 14 / 2.0 mm²
–
Cord length 10 m up to 30 m: AWG 12 /
3.5 mm²
18 Specifications English
0458-008-9601-A 33