2
1. Lay table top #1 painted side down, on a smooth, flat
surface. Use the shipping container to protect the
painted surface of the table top.
2. Assemble the two “L” tubes and the center tubes that
make up the “U” Support and the “U” Leg. Align on
Table Top as shown in Figure 1.
Note: “U” Leg is
larger and wider than the U Support. The U-
leg should be installed on the end of the table
half with the end rail mounting holes.
3. Put plastic caps #13 on the end of U-leg #2.
IMPORTANT:
Be sure the slot in the six U-clips #3 all face the same
direction (toward the end of the table with the U-
support) as shown.
4. Align the holes in the U-clips #3 with pilot holes in table top
assembly and secure with twenty four screws #20 as shown.
IMPORTANT: U-Leg is wider than U-support.
Make sure they are assembled exactly as
shown. If not, there will be a large gap between
table halves and table will not operate properly!
Figure 1
Figure 2
