Stiga LT 40 Li, Operator'S Manual

Page: 150 / 495

EN - 16
PROBLEM PROBABLE CAUSE SOLUTION
6. Excessive noise and/or
vibration is experienced
whilst working
Loose or damaged parts. Turn off the machine, remove the battery and:
- inspect for damage;
- check for and tighten any loose parts;
- have all replacements or repairs carried
out by an authorised service centre.
7. The machine gives off
smoke whilst working
Machine damaged Do not use the machine. Immediately turn
off the machine remove the battery and
contact an authorised service centre.
8. Battery power
reserve is low
Severe working conditions
requiring greater
current absorption
Optimise operations
(para. 7.2.1)
Battery is insufficient for
operating requirements
Use a second battery or extended
battery (par. 15.1)
Decrease in battery capacity Purchase a new battery
9. The battery charger
is not recharging
the battery
Battery is not correctly inserted
in the battery charger
Check it is correctly inserted (par. 7.2.3)
Unsuitable environmental conditions Recharge the battery in places with
suitable temperatures (see battery/
battery charger instruction manual)
Dirty contacts Clean the contacts
The battery charger is not energised
Check it is plugged in and the
power socket is energised
Faulty battery charger Replace with an original spare part
- If the problem persists, refer to the
battery/battery charger manual
If problems persist after implementing the solution, contact your Dealer.
15. ACCESSORIES ON REQUEST
15.1 BATTERIES
D ifferent capacity batteries are available to
suit specific operating requirements (Fig. 18).
The list of approved batteries for this machine
can be found in the "Technical Data" table.
15.2 BATTERY CHARGER
Device used to recharge the battery (Fig.19).