Stiga HT 40 Li, Operator'S Manual

Page: 118 / 387

EN - 11
13. MAINTENANCE TABLE
Intervention Frequency Notes
MACHINE
Check all fasteners Before each use para. 7.5
Safety checks/check controls Before each use para. 6.2
Check the battery charge status Before each use *
Recharge the battery After each use para. 7.2.2
*
Cleaning the machine and the engine After each use para. 7.3
Cleaning and lubrication of the cutting means After each use para. 7.4
Checking for any damage to the machine. If
necessary, contact the authorised service centre.
After each use -
Checking the cutting means After each use para. 8.1.1
Sharpening the cutting means - para. 8.1.2
**
Replacing the cutting-means - para. 8.1.3
**
* Refer to the battery/battery charger manual.
** The operation must be carried out by your Dealer or an Authorised Service Centre
14. TROUBLESHOOTING
PROBLEM PROBABLE CAUSE SOLUTION
1. Blade control lever
and safety switch
operated but the
machine will not start
Battery is not inserted or
is inserted incorrectly
Make sure that the battery is
inserted correctly (para. 7.2.3)
Low battery Check the battery status and recharge
if necessary (para. 7.2.2)
Hedge trimmer is damaged. Do not use the hedge trimmer.
Remove the battery and contact
an authorised service centre.
2. The motor shuts
down whilst working
Battery is not inserted correctly Make sure that the battery is
inserted correctly (para. 7.2.3)
Low battery Check the battery status and recharge
if necessary. (para. 7.2.2)
3. The cutting means is
stationary when the
blade control lever
and safety switch
are engaged
Hedge trimmer is damaged. Do not use the hedge trimmer. Immediately
turn off the machine remove the battery and
Contact an Authorised Service Centre.
4. The cutting means
overheats whilst working
Insufficient blade lubrication Turn off the machine, wait until the cutting
means is stationary, remove the battery
and lubricate the blades (para. 7.4)
5. The cutting means
comes into contact with
a line or electric cable
- DO NOT TOUCH THE BLADE AS IT
MAY BE LIVE AND BE EXTREMELY
DANGEROUS! Grasp the machine using
the insulated rear handgrip only and
position it at a safe distance from yourself.
Disconnect the current that powers the
severed line or mains cable and remove
the battery before freeing the blade teeth.