EN -
CHARGING PROCEDURE
NOTE
The battery is not
shipped fully charged. It is
recommended to fully charge
before use to ensure that
maximum run time can be
achieved. This lithium-ion battery
will not develop a memory and
may be charged at any time
1. Plug the charger into
an AC power outlet..
2.Insert the battery pack
(1) into the charger (2).
This is a diagnostic charger.
The Charger LED Lights
(3) will illuminate in specific
order to communicate the
current battery status.
They are as follows:
DESCRIPTION
LED STATUS
Battery is charging
●
Red
●
Red
Fully charged
●
Red
●
Green
Battery is too warm
(remove for approx. 30
min. to allow to cool)
●
Red
●
Orange
No battery present
●
Red
○
OFF
Defective battery
(remove and replace
with new battery)
●
Red
☼
Red
blinking
False Defect Note:
When the battery is inserted
into the charger, and the
status LED flashes, remove
the battery from the charger
for 1 minute, then reinsert. If
the status LED indicates
normal than the battery pack
is good. If the status LED
is still blinking, remove the
battery pack and unplug the
charger. Wait 1 minute and
plug the charger back inand
reinsert the battery pack.
If the status LED indicates
normal than the battery pack
is good. If the status LED is
still blinking then the battery
pack is defective and needs
to be replaced.
NOTE
When the red indictor
flickers, pull out the battery from
the charger and insert again
within 2 hours. If the indictor
shows charging, that means the
battery is good. After 2 hours,
please pull out the battery and
also pull out the AC power plug
of the charger for 1 miniute, and
then insert the AC power plug
and the battery again. If the
indictor shows charging, that
