ŷŷŷĪńŒê¼¼ùé¼ùŒļĒĉĪĒă
ZCŨÑ ZCŨĜƃ
3. Appliance description
The open vented (non-pressurised) appliance constantly
maintains the water content at the pre-selected temperature.
During heating, expansion water drips from the tap. The
appliance may only be installed with taps for open vented (non-
pressurised) water heaters (see chapter "Installation / Appliance
description / Accessories").
3.1 Operation
The required DHW outlet temperature can be set at the
temperature selector. The heat-up indicator illuminates during
the heat-up process.
Ĝō
’ ZCŨÑ
°C
= Cold. On this setting, the appliance is protected from
frost. The tap and the water line are not protected.
Eco = Recommended energy saving setting (approx. 60 °C), minor
scaling
85 = Highest selectable temperature
A qualified contractor can set a temperature limit on the
Note
appliance (see chapter "Installation / Settings / Setting
the temperature limit").
4. Cleaning, care and maintenance
Never use abrasive or corrosive cleaning agents. A damp
cloth is sufficient for cleaning the appliance.
Check the
tap regularly. You can remove limescale deposits at the
outlet using commercially available descaling agents.
When you are using a shower, the shower head must be
de-
calcified at regular intervals.
5. Troubleshooting
TļĒù¼ă
|şń¼
V¼ă¼®ź
The appliance does not
supply hot water.
The temperature selector Switch the appliance
ON is set to “°C”.
by turning the tempera-
ture selector.
No power at the appli-
Check the plug / fuses in
ance. the fuse box.
Water can only be drawn The aerator in the tap is
Descale / replace
the at a reduced rate.
scaled up. aerator.
Loud boiling noises in-
The appliance is scaled Have the appliance
side the appliance.
up.
descaled by a qualified
contractor.
If you cannot remedy the fault, notify your qualified
contractor. To facilitate and speed up your request, provide
the number from the type plate (000000-0000-000000).
Z|ϼŒź
6. Safety
Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
6.1 General safety instructions
We guarantee trouble-free function and operational
reliability only if original accessories and spare parts intended
for the appliance are used.
6.2 Instructions, standards and regulations
7. Appliance description
The open vented (non-pressurised) appliance is suitable only
for oversink installation. The appliance is intended to heat
cold potable water and supply it to a single draw-off point.
The appliance must only be installed with an open (non-
pressurised) tap (see chapter "Installation / Appliance
description / Accessories").
7.1 Standard delivery
Delivered with the appliance are the
following: - Wall mounting bracket
SN 10 SLi | SN 10 SL GB | SN 15 SLi | SN 15 SL 3.3 kW
- Mounting template (located for SN 5 SLi | SN 5 SL GB inside
these instructions)
Summary of Contents for SN 10 SL GB
Page 1: ......
Page 16: ...ZC ZC ZC...