iNSTaLLaTiON
installation
EN
GL
ISH
www.stiebel-eltron.com
SHF | SHS | SHL |
17
f
f
When raising the heating elements, ensure the through
holes in the side insulation are not widened by the heating
elements.
f
f
Insert the first storage block, with the heating element cavity
pointing upwards, with some clearance to the r.h. thermal
insulation.
f
f
Push the storage block up against the r.h. and back thermal
insulation. The long holes form the heating ducts.
D
00000
75
74
7
f
f
Insert the other storage blocks in the order shown.
D
00000
75
74
8
f
f
Push the cover panel taken from the interior of the appliance
over the upper storage blocks.
12.8 Cleaning the appliance
f
f
Clean the appliance after installation and inserting the stor-
age blocks. For this, proceed as follows:
D
00000
75
80
3
f
f
Remove the air routing assembly.
D
00000
75
80
4
1
1 Protective temperature controller (N5)
f
f
Lift the fan out. To do this, loosen the screws located at the
front on the retaining brackets.
f
f
Observe the cable routing.
With some appliances, the protective temperature controller (N5)
incl. retaining bracket must be unscrewed.
!
Material losses
When depositing the components you have removed,
ensure that the wires are not damaged.
f
f
Clean the floor plate and fan. Make sure not to damage the
fins.
f
f
Then refit the fan, and if necessary the protective tempera-
ture controller and air routing assembly.
f
f
Observe the correct cable routing.
12.9 Closing the appliance
D
00000
75
74
4
f
f
Insert the inner front panel again.
