7
© 2020 OJ Electronics A/S
RTF-TC
RTU-TC
© 2018 OJ Electronics A/S
RTF-TC / RTU-TC
FIG. 1 - CONTENT
• Thermostat
• Sensor
The thermostat is an electronic PWM/PI thermostat for tempera-
ture control by means of an NTC sensor located either externally or
internally within the thermostat.
The thermostat is for flush mounting in a wall socket. A baseplate
for wall mounting is also available.
This thermostat can be used as a controller for electric room heat-
ing pursuant to EN50559.*
* Only valid for RTF-TC (MCD5-1999)
Product programme
RTF-TC (MCD5-1999)
Clock-thermostat with two sensors:
floor sensor and built-in room sensor.
RTU-TC (MCC5-1999)
Clock-thermostat with built-in room
sensor.
FIG. 2 - WARNING – Important Safety Instructions
Disconnect the power supply before carrying out any installation or
maintenance work on this thermostat and associated compo-
nents. The thermostat and associated components should only be
installed by a competent person (i.e. a qualified electrician). Electri-
cal installation must be in accordance with appropriate statutory
regulations.
FIG. 3 - THERMOSTAT PLACEMENT
Mounting of sensor
The floor sensor contains a safety extra-low voltage (SELV) circuit,
allowing it to be placed as close to the floor surface as possible
without having to take account of the risk of shock should the sen-
sor cable become damaged. The two wires connecting the sensor
to the mounting box must be additionally insulated, e.g. shrink flex.
Instruction
English
BR1017A14
BR1017A07
BR1017A17
