32
|DHE SLi www.stiebel-eltron.com
InStaLLatIOn
Installation
10.1 completing the installation
26
�02
�02
�1
102
�
f
f
Fit the lower part of the back panel. Ensure that it clicks into
place.
f
f
Align the mounted appliance by loosening the fixing toggle,
aligning the power supply and back panel, and then re-tight-
ening the fixing toggle. If the back panel of the appliance is
not flush, the appliance can be secured at the bottom with an
additional screw.
10.2 alternative installation methods
- Power supply from above for unfinished walls
- Power supply for finished walls
- Large cross-section for power supply from below
- Connecting a load shedding relay
- Water installation for finished walls
- Water installation for finished walls with solder / compres-
sion fitting
- Water installation for finished walls, fitting the appliance
cover
- Installation of lower part of back panel with threaded fitting
for finished walls
- Use of existing mounting bracket when replacing an
appliance
- Installation with offset tiles
- Turned appliance cover
- Operation with preheated water
Power supply from above for unfinished walls
26
�02
�02
�1
12
3�
f
f
Cut off the cable grommet for the power cable.
f
f
Push down the locking hook that secures the mains terminal,
then remove the mains terminal.
f
f
Reposition the mains terminal in the appliance from the
bottom to the top and secure the mains terminal by sliding it
under the locking hook.
26
�02
�02
�1
30
6�
f
f
Route the control wires below the wire guide.
Power cable for finished walls
f
f
Cut or break out the required entries in the back panel and
appliance cover cleanly (for positions, see chapter "Specifica-
tion / Dimensions and connections"). If necessary, use a file.
f
f
Route the power cable through the cable grommet and con-
nect it to the mains terminal.
Note
This type of connection changes the protection rating of
the appliance.
f
f
Change the type plate. Cross out "IP 25" and mark
the box "IP 24". Please use a ballpoint pen to do this.
large cross-section for power supply from below
If cables with a large cross-section are used, the cable grommet
can be fitted after the appliance has been installed.
1.
3.
4.
2.
26
�02
�02
�1
12
4�
f
f
Before installing the appliance, use a screwdriver to push the
cable grommet out.
f
f
Push the cable grommet over the power cable. For this, use
the installation aid. In the case of a cross-section > 6 mm²,
enlarge the hole in the cable grommet.
f
f
Push the cable grommet into the back panel.
299680_DHE_18-27_SLi_de_en_fr_nl_pl_cs_bg_ru.indb 32
05.03.2013 08:38:20