STIEBEL ELTRON
8
1. Installation Instruction
for the qualified installer
- In the case of laying the cable from
above and from the side, create an open-
ing for the electric cable using a pair of
pliers to pinch or break the plastic chip
on the side or on the top of the heater as
appropriate, so that the cable is tightly
secured to the unit.
- Insert the cable through the rub-
ber seal at the rear of the unit. Please
ensure that the power is turned off at
the mains.
- Hang the heater on the screws mounted
on the wall, and slide the heater down
into position.
- A circuit breaker or power control
switch should be installed before the
unit. The size of the circuit breaker must
correspond to the voltage of the heater
(check the size of the circuit breaker in
the Technical Information section).
- Measure and cut the insulation at the
end of the wire in preparation.
- Insert the wires into the respective
openings according to the diagram, and
fasten the screws to secure the wires
tightly. Please ensure that the correct
size of wire is used.
Fig 12
Fig 13
Fig 14
Fig 15
