INSTALLATIoN
Installation
22
| CNS TREND | CNS TREND U www.stiebel-eltron.com
10.2 Installing the wall mounting bracket
The appliance is intended for wall mounting using the wall mount-
ing bracket supplied. The appliance may only be installed hori-
zontally.
Note
- The wall mounting bracket can be used as a tem-
plate for wall mounting. This ensures sufficient
clearance from the floor.
- Use a spirit level if the floor is uneven or sloping.
aaa
D
00000
72
15
9
1
3
2
4
≥224
≥224
D
00000
72
31
2
f
f
Unhook the wall mounting bracket from the appliance.
f
f
Place the centred wall mounting bracket horizontally on the
floor. Mark holes 1 and 2.
f
f
Lift up the wall mounting bracket so that its lower holes
match up with the markings you have just made on the in-
stallation wall.
f
f
Mark holes 3 and 4 on the installation wall.
f
f
Drill the holes at the 4 markings.
f
f
Secure the wall mounting bracket with suitable fixing ma-
terials (screws, rawl plugs). With the vertical slots, you can
compensate for an offset fixing hole.
10.3 Appliance installation
f
f
Hook the appliance onto the bottom tabs of the wall mount-
ing bracket by the slots in the back of the appliance.
f
f
Place the appliance in an upright position.
f
f
Secure the appliance by pushing it towards the wall until it
audibly snaps into place in the two upper springs on the wall
mounting bracket.
D
00000
72
15
7
1
1 Wall mounting bracket
f
f
Secure the appliance against unintentional release using
the supplied locking screw on the left-hand side of the wall
mounting bracket.
D
00000
72
15
8
1
2
1 Appliance
2 Locking screw
10.4 Removing the appliance
f
f
Undo and remove the locking screw from the wall mounting
bracket.
f
f
To release the appliance, push down the springs at the top of
the wall mounting bracket.
f
f
Tilt the appliance away from the wall and lift it off the bottom
tabs on the wall mounting bracket.
