case
5mm LED mounting bez
el (1)
#7432
5mm white LED (1)
#7422
case
The LED mounting bezel consists of two main parts: a
ring that the LED fits into, and a plastic plug that goes
over the LED from the back side to keep it in place.
Install the mounting bezel through the front of the
enclosure. From the inside, slip a lock washer and nut
on and tighten it up using a 3/8" socket. Insert the LED
into the bezel so the flat side (the shorter lead) faces to
the right side of the case when looking from the back.
Feed the leads through the plastic plug, press the plug
down until it’s tight in the bezel. The LED will be held
in place when you solder the leads to the switches and
circuit board. For a more secure mount, you can run a
bead of clear silicone adhesive around the plastic plug.
12
INSTALL 1
LED
INDICATOR
LIGHT
Like some of the caps and diodes,
the LED is polarized and has to be
installed in a specific direction. The
negative lead of the diode has a flat
edge and is shorter than the positive.
+
+
.2
2J
63
1J63
.1
J6
3
IN GND SW OUT
The circuit board is held in place by the
control pots, but the LED leads need to
pass through their eyelets in the PCB
before the pots will pass through the
enclosure. Pass the longer
positive lead through
the hole marked “A”
and the shorter negative lead through
the hole marked “K”. Once the pots are
secured to the enclosure, solder these
leads in place. Install their shafts through
the top of the case, and thread washers onto them on
the outside. Using a 10mm wrench, install the mounting
nuts so they are good and snug, but take care not to
overtighten.
Install the footswitch through the top of the case and
thread a washer onto it from the outside. Use a 14mm
wrench to tighten it up. The footswitch is the effect bypass
switch that turns the pedal on.
Do not connect any of the lead wires at this point. Once all
of the pots are tightened down, twist the pot shafts all the
way counter-clockwise and install the knobs pointing at “7
o’clock” indicating a the “zero” position.
