One 3-way toggle switch is included with the kit. Slide the switch lugs through the back
of the the three PCB holes at the top of the board and solder them.
You can use the pedal enclosure as a mount for the toggle switch while you solder the
PCB board to it. Just lay the enclosure face-up and drop the switch in its hole, you don’t
even need to fasten it with a nut from the back if you don’t want to.
INSTALL 1
SWITCH
6
.2
2J
63
1J63
.1
J6
3
.2
2J
63
1J63
.1
J6
3
The kit comes with 24" of lead wire.
Cut the wire into eight 2" sections and two 4" pieces.
Strip around 3/32" off both ends of all wires.
Solder the eight 2" leads on to main board in the
locations shown in the diagram.
INSTALL 8
LEAD WIRES
7
We find it easiest to feed the free end of
each lead through the bottom of the PCB
and solder it on the top of the board.
TIP
