The extension and retraction limit switches have been preset at the factory.
In general, we advise you to avoid readjusting these switches.
In some cases, to enable proper alignment of the displayed image on the
screen, you may need to adjust the extension of the screen. If adjustment
to the extension is necessary, carefully follow these instructions.
Modifying the extension of the screen
You can increase the extension of the screen up to 3" (7.5 cm) past the
factory preset stop, or you can decrease the extension by approximately
4-6" (10 - 15 cm) from the factory preset stop. Do not attempt to modify the
screen extension beyond these recommended amounts.
The limit switches are located on the left side of the screen roller tube inside
the case, as shown in Figure 11.
To increase the screen's fully extended (screen down) stop position:
1. Lower the screen to its current stop position.
2. Locate the white extension (down) limit switch on the left side of
the screen tube. You access the white limit switch through the
small electrical grommet located on the case next to the end
plate. Use a small electrician’s style screwdriver or a 5/32”
(.4 cm) hex wrench to turn the switch in a counterclockwise
direction. If the power is still on, the screen will drop
incrementally as the switch is turned.
Note:
One complete turn of the switch will make approximately a
3/4" (2 cm) change in the screen's stop position.
Luxus A Electriscreen: Owner’s Manual
13
A
DJUSTING THE
S
CREEN
E
XTENSION
Caution
Improper adjustment of the limit switches can cause
irreparable damage to the screen itself, resulting in voiding the
factory warranty.
Warning!
The screen is fully retracted when the batten is flush with the
bottom of the case. Do not attempt adjustments with the
yellow retraction (UP) limit switch that will further retract the
screen. Incorrect adjustment of the switch will cause severe
screen damage. Consult the factory if you have any questions.
Figure 11:
Underside view of
Luxus
Down Limit Switch
Up
Limit
Switch
Screen
