The motor requires standard 120V 60 Hz input (unless an alternate voltage
has been specified). All connections are made to the electrical box on the
side of the unit (audience left).
There are several kinds of switch controls available. Follow the installation
procedure for the type of switch control you will install.
General suggestions for wiring:
K
Soldering is recommended.
K
The use of wire nuts is acceptable.
6
Stewart Filmscreen Corporation
S
TEP
2. E
LECTRICAL
H
OOK
-
UP
Caution
Professional techniques need to be adhered to when
making any electrical connection. A qualified electrician
should perform these procedures.
Be sure to follow all standard safety procedures for
installing electrical devices.
Do not disassemble or alter the configuration of the motor
or the unit's electrical connections. This may cause injury to
you or damage to the product.
The electrical connection should be made only to the type
of power source indicated on the marking label.
