TIGER Chipper Shredder CS7-205V & CS7-305V Owners Manual (P/N 1432)
page 8
When this equipment is stopped for servicing, inspection, or storage, make sure the spark plug wire is disconnected
from the spark plug. Allow the machine to cool before making any inspections, adjustments, etc. Maintain the
machine with care and keep it clean by blowing, brushing or wiping it down.
DO NOT WASH OR USE WATER.
Store the machine out of the reach of children and where fuel vapor will not reach an open flame or spark. For
extended storage periods, run the unit dry of fuel. Always allow the machine to cool before storing.
Chipper Blade Re
-
sharpening
When the chipper blades are blunt, the machine will lose its self
-
feeding action and the material has to be pushed
in. Often it comes out in long strips.
The chipper blades need to be turned over to present a new edge if there is one, or remove for sharpening. To
remove the blades, open the discharge chute. With a 13 mm ring spanner remove the blades. Be careful not to drop
the nuts, bolts or blades into the chipper.
The chipper blades should be sharpened on a surface grinder or replaced with new ones. Make sure there is plenty
Maintenance
Service and Maintenance Schedule
Frequency
Component
Maintenance Required
Refer to
Engine
Operators
Manual
Before
each Use
Every
8hrs
Every
25hrs
Every
50hrs
Engine Oil
Change¹
✓
Fuel filter
Replace
✓
Spark Plug
Check Condition & Gap
✓
Engine Oil
Check / Fill
✓
Fuel Tank
Check / Fill
✓
All internal &
external nuts &
bolts
Check Tightness
✓
Tyre Pressure
Check
✓
Chipper Anvil
Check Clearance & re
-
Torque
to 40 ft
-
lbs²
✓
Chipper Blades
Check Sharpness & re
-
Torque
to 18.6 ft
-
lbs ²
✓
Shredder Blade
Check Condition
✓
Entire Machine
Clean
✓
Drive Belt
Check
✓
Belt Tension
Check
✓
Belt/Pulley
Alignment
Check
✓
Rotor Shaft
Grease Nipples
Lube
✓
(¹) Perform more frequently under extremely dusty conditions
(²) Perform more frequently when chipping dry or dirty wood
