14
Indicators LED
POWER (blue LED):
Indicates amplifier operation
when it is on.
PROT (top red LED):
Indicates that the amplifier
encountered malfunctions and entered protection
mode, forcing it to shut down. Verify in the
protection
table below
the possible problem and turn on the
amplifier again.
CLIP (lower red LED):
Indicates signal distortion at the
amplifier output.
Problem:
Short circuit or output overload.
Solution:
Check that the speaker cables are well
isolated.
Verify the minimum impedance supported.
Solution
:
Verify that the amplifier is in a ventilated
place or that the coolers are not obstructed.
Problem:
Overheating
Solution
:
Battery consumption is normal when using
the amplifier. Recharge the battery.
Solution:
Verify the power supply/battery system.
Problem:
Low battery.
Problem:
Tension higher than allowed.
Smart protection system
In case of problems, the amplifier will turn off and the
PROT LED
will flash.
Depending on the problem, the led will flash a certain number of times
indicating the cause of the problem, as shown in the table below:
1 x
2 x
3 x
4 x
