12
Input, output and audio controls
1. COOLERS:
It provides cooling of the amplifier. Install in a cool place
without obstruction of air inlets and outlets.
2. INPUT:
Input of the signal to be amplified. Connect to the radio/player
through high quality shielded RCA cables to prevent unwanted noise.
3. LEVEL:
Signal level control in the amplifier input.
4. CROSSOVER
• FILTRO HIGH PASS (HPF):
This variable control allows you to select the
initial frequency from
10Hz to 90Hz
that will be reproduced by the amplifier.
• FILTRO LOW PASS (LPF):
This variable control allows you to select the final
frequency from
90Hz to 12KHz
that will be reproduced by amplifier.
• BOOST:
Variable control for bass boost from
0 to + 10dB
.
• FREQ:
Variable control for
BASS
boost action from
30Hz to 70Hz
.
6. FLAT:
This switch allows you to turn the
FLAT
mode on or off. Settings made on
the
CROSSOVER and BOOST
controls will be turned off when using this mode.
7. CONECTOR DE SAÍDA (SPEAKERS):
MONO output of amplified signal
for speakers connection. Check the minimum impedance and polarities
before performing the installation.
2
3 4
5
6
7
1:
Cooler
1:
Cooler
