10
If the control is already programmed the siren will emit 1 beep. Each time a new
control is programmed to the control panel the memory is cleared. Therefore all
existing controls must be reprogrammed with the new one or they will not work.
Before checking the control panel, give it 10 seconds after it has been activated to
stabilize all the sensors.
TURN ON
IGNITION
PRESS THE MASTER BUTTON
3.1. TRIGGERED ALARM
When the alarm is triggered, it immediately locks down. The alarm sounds for one
minute, then waits 10 seconds and reads the sensors again. After the alarm has been
triggered ten consecutive times by the accelerometer, this sensor is ignored until the
next activation, unless the motorcycle is turned on.
• Press button for 3 seconds. A beep will sound, the motorcycle’s panel will be
activated, and if the button is pressed within 10 seconds the ignition will turn on
(gray wire, positive current)
. As long as the button is held the output remains active.
• To turn on the ignition, the motorcycle must be in
Neutral
.
• If you need to start the ignition again, press the button and then in 3 seconds .
• To turn off the motorcycle press the button, 2 beeps will sound and the motorcycle
will turn off.
• If the motorcycle is in gear, it will not be switched off to prevent it from accidentally
turning off when in motion.
3.2. USING THE CONTROL TO TURN ON THE MOTORCYCLE
(ONLY MOTO TRIPLO i)
UNTIL THE SIREN
BEEPS
TURN OFF
IGNITION
PRESS
FOR 3 SECS.
SIREN EMITS
1 BEEP
PANEL TURNS ON
AUTOMATICALLY
MOTORCYCLE TURNS ON
N
PROGRAMMING CONTROLS
2
ALARM FUNCTIONS
3
PRESS
The control panel can be switched on and off by programming
(see table section 12,
function 2)
.
ENABLE OR DISABLE ALARM
4
EMITS 3 BEEPS FOR EACH
PROGRAMMED CONTROL
PRESS
AND TOGETHER
