STERWINS ETHT2-50.3, Safety Instructions

Page: 225 / 232

5.TROUBLESHOOTING
Problems
Possible cause Solution
Product does not
start
Not connected to power supply Connect to power supply
Power cord or plug is defective Check by a specialist electrician
Other electrical defect to the
product
Check by a specialist electrician
Product does not
reach full power
Extension cord not suitable for
operation with this product
Use a proper extension cord
Power source (e.g. generator)
has too low voltage
Connect to another power source
Air vents are blocked Clean the air vents
Unsatisfactory
cutting
performance
Blade is worn/damaged
Have it replaced with new one,and need
to sent it to after sales service agent for
replacing.
Thickness of branches exceeds
capacity
Only cut branches complying with the
capacity
Excessive
vibration/noise
Blade is damaged
Have it replaced with new one,and need
to sent it to after sales service agent for
replacing.
Bolts/nuts are loosen Tighten bolts/nuts
Suspected malfunctions are often due to causes that the users can fix
themselves. Therefore check the product using this section. In most
cases the problem can be solved quickly.
225
EN