STERWINS 3276000376804, Manual

Page: 223 / 233

5.TROUBLESHOOTING
Problems
Possible cause Solution
Product does not
start
Not connected to power supply Connect to power supply
Power cord or plug is defective Have it checked by a specialist electrician
Other electrical defect to the
product
Have it checked by a specialist electrician
Product does not
reach full power
Extension cord not suitable for
operation with this product
Use a proper extension cord
Power source (e.g. generator)
has too low voltage
Connect to another power source
Air vents are blocked Clean the air vents
Unsatisfactory
cutting
performance
Blade is worn/damaged Have it replaced with new one
Thickness of branches exceeds
capacity
Only cut branches complying with the
capacity
Excessive
vibration/noise
Blade is damaged Have it replaced with new one
Bolts/nuts are loose Tighten bolts/nuts
Blade cover :
Remove the blade cover 9 from the blade 5 before operation
Align and push the blade cover 9 onto the blade 5 to attach it.
NOTE: Always attach the blade cover 9 when the product is not in use, for storage and
transportation.
To install :
To attach, align and slide the battery pack onto the slots of the battery docking
port until it locks in place.
To remove : To release, press the battery unlock button and remove the battery pack from
the product.
Installation
222
EN