stertil-KONI ST 1065-FWF, Service And Parts Manual

Page: 20 / 132

Service and Parts manual (Version B) 20 Wireless
3. Shutdown. If the machine is in operation, shut it down with the normal shut down
procedure. For more information, refer to section Switch off.
4. Machine isolation. Isolate the machine from the energy source(s). The machine
uses the following energy sources:
• AC / DC power, this is de-energized by removing the AC connection to the
machine.
• Battery, this is de-energized by disconnecting the battery and protecting the
battery terminal.
5.
Lock-out (or tag-out) device application. Lock-out the energy isolating device(s)
with:
• Individual lock(s)
• Place a warning device on the main switch
6. Remove residual or stored energy. Stored or residual energy (such as that in
capacitors, air pressure, etc.) must be dissipated or restrained by methods such as
grounding, bleeding down, etc.
7. Verification of isolation
• Make sure that no persons are in or on the machine.
• Make sure that the machine is disconnected from the energy source(s).
• Test to verify the isolation of the machine.
• Make certain that the machine will not operate (power cannot be turned on)
CAUTION
Return all operating control(s) to the OFF position after verifying the isolation
of the machine.
The machine is now locked out.
2.5.2 End lock-out / tag-out procedure
1. Make sure the service or maintenance is completed and the machine is ready to
return to normal operation
2. Check the machine and the immediate area around to make sure that all
nonessential items have been removed.
3.
Make sure that all components of the machine are operationally intact.
4.
Make sure that all persons are at a safe distance from the machine.
5.
Verify that the power switch is in the OFF position.
6.
Remove the lockout devices.
7. Notify all personnel that the service or maintenance is completed and the machine
is ready for use.