Stern TMS210A, Operating Instructions Manual

Page: 13 / 35

ENGLISH | 13
Sawing straight cross-cuts (fig. F, G & J)
Straight cross-cuts are performed with the machine set up in the mitre saw position or in the table saw
position. While sawing straight cross-cuts when using the machine in the mitre saw position the
workpiece is placed against the fence and sawn through transversely. While performing the same cut
when using the machine in the table saw position the workpiece is placed against the guide fence.
For sawing straight cross-cuts in the mitre saw position, proceed as follows:
Keep the workpiece pressed to the table and the guide fence (13).
Switch on the machine.
Depress the head with equal force to allow the saw blade to cut through the workpiece and enter
the table slot
Switch the machine off as soon as the cut is completed. Only raise the head after the saw blade
has come to a complete standstill.
For sawing straight cross-cuts in the table saw position, proceed as follows:
Set the guide fence (17) for sawing straight cross-cuts.
Place the workpiece lengthwise against the profile and set the guide profile (37).
Switch on the machine.
Securely hold the workpiece and guide it along the saw blade keeping it pressed against the guide
fence.
Switch the machine off as soon as the cut is completed.
Sawing mitre cuts (fig. F, G & K)
Mitre cuts are performed with the machine set up in the mitre saw position or in the table saw position.
While sawing mitre cuts when using the machine in the mitre saw position the workpiece is placed
against the fence and sawn through transversely at an angle. While performing the same cut when
using the machine in the table saw position the workpiece is placed against the guide fence.
For sawing mitre cuts in the mitre saw position, proceed as follows:
Set the mitre angle.
Proceed as described for sawing straight cross-cuts in the mitre saw position.
For sawing mitre cuts in the table saw position, proceed as follows:
Set the guide fence (17) for sawing mitre cuts.
Proceed as described for sawing straight cross-cuts in the table saw position, starting in point 2.
Sawing bevel cuts (fig. L)
Bevel cuts are performed with the machine set up in the mitre saw position. While sawing bevel cuts, the
workpiece is placed against the fence and sawn through at an inclination.
Set the bevel angle.
Proceed as described for sawing straight cross-cuts in the mitre position.
Sawing compound mitre cuts (fig. F & M)
Compound mitre cuts are performed with the machine set up in the mitre saw position. While sawing
compound mitre cuts, the workpiece is placed against the fence and sawn through in a combined mitre
and bevel cut.
Set the mitre angle.
Set the bevel angle.
Proceed as described for sawing straight cross-cuts in the mitre position.