Using your Vacuum
1. Insert the power plug into the wall outlet.
2. Connect hose and telescopic tube if desired.
3. Correctly place shoulder straps on each shoulder and secure the waist band with hook and loop strips. (Fig. 17)
CAUTION:
If the waist band and both shoulder straps are not properly and securely in place, the unit could fall off your back
causing damage or injury.
WARNING:
To reduce the risk of electric shock, the power cord must be disconnected before removing the dust bag, shake-
out bag, changing the filters or performing maintenance or troubleshooting checks.
4. Turn the unit on by pressing the switch located near the base of the unit. (Fig. 18)
Fig. 17
Fig. 18
Removing & Replacing Dust Bag
To remove the dust bag from the vacuum:
Important:
DO NOT use the vacuum without all filters, shake-out bag and dust bag in place.
1. To remove the dust bag, press on the canister lid tabs on each side of the unit and lift canister lid. (Fig. 19)
2. Pull the tab on the dust bag holder out slightly and upwards.
3. Holding the dust bag in your hand, slide out the bag’s cardboard top from the slots in the bag holder. (Fig. 20)
4. Replace the dust bag with a new bag. DO NOT reuse the same bag.
5. The card board face of the new bag should rest securely in the dust bag cover guides. (Fig. 21)
6. Replace the shake-out bag in the vacuum.
7. To replace the dust bag holder, flip the holder and press tab until it clicks and is engaged.
8. Replace the canister lid onto the vacuum.
WARNING:
Never over fill the dust bag. Replace dust bag when bag is 3/4 full. Clean the cloth shake-out bag each time dust
bag is replace.
Fig. 19
Fig. 20
Fig. 21