Sterling Models Kingfish Sailboat, Assembly Manual, Page: 5 / 17

Page
5
of nut against plywood. Secure the nuts with cement or solder. Apply a coat of cement to the bottom of
the frame that contacts the hull and set the frame into the hull. Be sure it is seated firmly in place. The
center board slot on the bottom of the hull is sealed with epoxy cement. Apply a bead of epoxy along
the slot and smooth out with your finger.
Cut two pieces of ¼” square hardwood 1 7/8” lo ng. These strips are mast supports and are cemented on
top of the inner deckl#10 and back of bulkhead #7 on either side of the mast hole. Be certain they are
vertical and spaced1/2” apart for the mast to fit properly.
Figure 4