Ensure mains at the power panel are turned off before connecting power to the controller. Apply any necessary
protection to assure that mains are not accidently turned on during the installation.
1) Make sure all the circuit breakers in the
controller are turned off.
2) Confirm the controller being installed is designed
for the line voltage and intended load(s). Check
labels, circuit breakers and fuse sizes before
installing.
3) Connect the door switch to two terminals on TB1
marked “DOOR”. The door switch is low voltage
24vac.
TB1
– Torque
AGW
In. Lb.
18-22
3.5
4) The enclosure meets type 4 approval for water
resistance. Use fittings that are consistent with
the environmental rating of the enclosure. Use
proper torque values.
5) When drilling holes, use caution as to not
damage internal components. Use the markers
inside the enclosure for safe drilling locations.
Ensure that holes are not close to each other
and away from the edge of the door to help
prevent cracking.
6) Remove the screws that secure the inner door.
This compartment should be opened by a
qualified electrician only!
7) Connect BMS. BMS includes Door and/or
watchdog.
8) Connect Bank-1 and Bank-2. Ensure that both
banks carry relatively equal load for proper
watchdog operation. Ensure proper circuit
breaker and grounding wire torque
9) Connect Mains. Ensure proper circuit breaker
and grounding wire torque
10) Torque the circuit breakers CB1, CB2 & CB3.
CB1, CB2 & CB3 - Torque
AGW
In. Lb.
3 to 12
13 to 17.5
11) Torque ground bar TB2.
TB2
– Torque
AGW
In. Lb.
4 to 6
45
8
40
10 to 14
35
12) Close inner door and secure the screws.
13) Turn on the mains at the power panel on.
14) Turn on the mains in the Simple Controller.
15) The RED stop light should be illuminated.
16) Turn on the Bank1 and Bank2 circuit breakers.
17) Close and latch the Simple Controller front door.
18) Press the Green Start Button.
19) The emitters should be illuminated.
1) If applicable, Connect Watchdog BMS relay to a BMS system.
Watchdog
– Torque
AGW
In. Lb.
16-26
1.7
2) Reset the watchdog by press and hold the reset button until the green light is constant.
3) The following conditions will send an alarm to the BMS system:
a) If a bank LED is Red.
b) Power loss.
No LED’s are light.
I
NSTALLATION
W
ATCHDOG
Summary of Contents for 8100PVAB
Page 6: ......
