Steren SEG-150, Instruction Manual

Page: 49 / 52

23
Access using DAP code (Direct Access to Programing)
This procedure is to enter the programming mode when master the code is
lost.
- Turn off and unplug the access control. Wait 1 minute to ensure it is fully
discharged.
- Plug in and turn on the control. For a 1 minute the control is in boot mode and
you can enter the following sequence:
Exit 8080 + **
Where:
Press the start button once
8080 is the code DAP. This cannot be changed.
** to confirm.
After entering this sequence, the master code is deleted, power tone will turn
off and control will emit two beeps and access LED will light on
Note: If you do not press the start button and the DAP code during the
boot period, the control will start normally.