Steren BL-526-106, User Manual

Page: 18 / 20

Set the scanning time, signal range, connect the wireless access point(WAP), brightness, language
and factory reset.
Operating Instruction:
a. Press “ Menu ” button to pop-up the menu list and select “ Setting ”.
b. Press “ Up ” and “ Down ” to select target setting.
c. Select “Scan interval”, then click “Enter” to set scan time interval, 5 level s to select, refer
to photo #5.9.5.
d. Select “signal range” and press “up” “down” “left” and “right” to set up the signal range.
e. Select “Wireless connect setting ” and target“ SSID ” , it will pop-up the keyboard, after
entering password and press “ CLEAR ” to exit the keyboard, then select “ OK ” , check if new version
is ready to update, if so, click install to follow the instructions,refer to photo#5.9.2
f. Select “ Bright ness” to pop-up the brightness adjustment messagebox, press “ Left/Right ”
to adjust the brightness, then press OK or “ Clear ” to exit, refer to photo#5.9.3.
g. Select Language: there are English, Spanish and French three languages, choose your
target“ language ”.
h. Factory reset: click and select confirmation, the system will restart to restore the original
factory settings.
6.0. Interface of About
Function:
1. About product info& version introduction
2. Check if there is new version to be upgraded.
Operating Instruction:
While you have connected to the internet, the updated software revision will automatically
pop-up and you just follow the installation instructions, or you could ignore it and upgrade later
when you are available
by clicking “CHECK UPGRADE”, updated software revision is always ready
to be downloaded and installed.