MOTION SENSOR
USER MANUAL
4
* To mute the alarm, slide the switch to OFF.
IMPORTANT
CAUTIONS
INSTALLATION OF THE SUPPORT
BATTERY PLACEMENT
HOW TO USE
SPECIFICATIONS
Before to use the product, please read carefully this manual to avoid any
malfunction. The info in this manual is shown as reference.
Due to updates can exist differences. Consult our website www.steren.com to
obtain the current version of this manual.
• Always use a soft and dry cloth to clean it.
• Don’t use or store the device in places where exist water or splashes.
• Don’t place heavy objects over the
• Avoid dropping the device, it could cause severe damage.
• This product is NOT a toy; keep it away from children.
To have access to battery compartment.
Turn the base as shown below.
Remove the battery compartment cover.
Take out the holder and insert a 9V
battery. Ensure that the polarity is right.
Carefully remove the base
as shown below.
Set the device into the base
again and the sensor on the
screws.
Use the support to make drill marks
into the surface where you want to
install the device.
Drill. Then insert anchors and screws,
ensure that the screws sticks out from
the wall some milimetres.
1
1
2
2
3
3
Alert (Constant sound)*
Alert type bell (Emits two tones)
Input: 9 V - - - (1 x 6LR61)
Motion detection speed: 0.6 – 1.5 m/s
Operating temperature: -20 to 40°C
Consumption: 0.5 W/h
Stand-by power consumption:
Not applicable
Specifications may change without
notice
Turn off the sensor
A) Turn
B) Lift up
C) Remove
Slide the switch to select an alert mode. You must wait for 30 seconds until the alert is ready.
When the sensor detects movement will sound according with the alert mode.
