13
Step 9:
Place the acrylic panel on top of the hex standoffs and fasten using the pan head screws
that were removed in the previous step.
Fig. 20
Finished wireless remote board.
Controller Setup
1.
Connect the controller power, 24 to 33 VDC.
2.
From the
Setup >
Options
menu, turn Remote ON and Driver Delay ON.
3.
Antenna selection – select the correct antenna model from the
Setup >
Antenna Selection
menu.
4.
Test the link before deploying remote board. Set the boards up next each other and make
sure the controller is seeing the remote board, both GHE radio boards should have all their
LEDs lit. Check the
Setup > Software Version
menu to make sure the firmware version (117)
for the remote board is being displayed.
5.
The GHE radio LEDs inside the SDA can be viewed through the rear center air vents.
6.
There will be a “
driver problem”
message on the SDA controller display if the remote driver
is not attached to the antenna. You should check the
Setup > Fault Code
menu to make
Note: If you are using an SDA 2000 you will need to have firmware version 117 installed in order to use the
wireless driver link. You can check your firmware version in the Setup > Software Version menu. Contact
with inquiries regarding upgrading your firmware.
